4/29/2024 0 Comments Medieval repeating crossbow![]() ![]() They serve the same purpose as an archer's fingers. The parts of the nut left at the sides are called the nut's fingers. The nut has a slot at the top through which the bolt is pushed against the string. The nut can also be made of steel or other durable metal, in which case no extra reinforcement is necessary. The nut was often made of horn or antler, in which case the place where trigger contacts the nut (bottom right) was reinforced with steel. These techniques ensured that the nut did not fall off the socket even in case of steel bolts the socket bore the load of the bowstring. Alternatively cord was passed through the hole and bound to the underside of the stock. Especially in late-medieval models the nut may have had a hole in the center to receive a bolt or a pair of screws. ![]() If a metal nut is used, a metal (or metal-plated) socket and oil will reduce friction greatly, reducing chances of misfire. Sometimes the socket was reinforced with horn or steel. The lock consists of four parts:Īlthough this picture showed an axle going through the nut, in Medieval times the nut was usually held in place by simply fitting tightly into a socket carved into the stock. The simple nut and trigger lock was the very common in the Medieval times. For practical instructions on how to make the nut, refer to this article. This article describes design aspects of a simple nut and trigger lock commonly seen on medieval crossbows.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |